Table of Contents

Controller

Reconnect

Reconnects communication between controller and software. This comes handy when communication is terminated due to e.g. EM interference.

Reset

Resets controller.

Firmware Update

Updates controller firmware with version embedded in software.

It is not possible to destroy or damage controller with firmware update. If firmware update fails it is always possible to update it again.

Advanced

Set Parameters

DHCP
DHCP status of controller.

IP
IP address of controller.

Mask
IP address mask.

Port
IP address port.

MAC
MAC address of controller

Revert to obsolete V1 firmware

Controller can be used with both motion software's from PlanetCNC. 'PlanetCNC TNG' software and obsolete 'CNC USB controller' software.

Controller's firmware needs to be updated with software version that will be used with, 'PlanetCNC TNG' or 'CNC USB controller' software.

Controller updated with 'PlanetCNC TNG' firmware cannot be used with 'CNC USB software' unless firmware is changed with 'Revert to obsolete V1 firmware' command. After this command controller firmware needs to be updated with 'CNC USB controller' software.

Controller updated with 'CNC USB controller' firmware cannot be used with TNG software until firmware is updated with 'PlanetCNC TNG'.