Introduction
Overview
Installation
Emergency Stop
Start
Stop
Pause
Start Options
Overrides
Speed Override
Spindle Override
Pause Enable
Pause Optional
Single Step
Mist
Flood
Spindle
Output
ExtOut
Motor, Limits, Probe
Motors Enable
Soft Limits Enable
Hard Limits Enable
Probe Trigger
Tools
Current
Change
Select
Edit Tool Table
Edit Tool Slots
Measure Current Tool
Measure All Tools
Move
To Zero
To...
Axis To Zero
To G28, G30
To Selected Line
To Mark
Program Bounds
Position To Camera
Camera To Position
Camera To Sel. Line XY
Machine Position
To Zero
To...
Axis To Zero
Unwind
Measure Height
As G28, G30
Reset THC
Work Position
To Zero
To...
Axis To Zero
From Program
Measure Height
Offset To Zero
Offset To...
Offset Axis To Zero
Selected Line
Camera
Coordinate System
Current
Select
To Zero
To...
Axis To Zero
Measure Height
Offset To Zero
Offset To...
Offset Axis To Zero
Edit Coordinate Systems
Tool Offset
Enabled
To Zero
To...
Axis To Zero
Measure Length
From Tool Table
Home
Cycle
Mill Facing
Mill Profile
Mill Pocket
Mill Circular Pocket
Drill
Drill Tap
Turn Facing
Turn Roughing
Turn Repeating
Turn Finishing
Turn Grooving
Turn Threading
Measure
Probe Calibration
Edge Find
Edge Position
Edge Angle
Inside Corner
Outside Corner
Hole
Protrusion
Slot
Tab
Surface Height
Surface Angle
Surface
Gantry Square
Points
Count
Load
Save
Save STL
Save DXF
To Output
Clear
Add From Position
Add From Camera
Camera
Show
Mark
Read
Calibrate Scale
Set Offset
User Commands
Controller
Reconnect
Reset
Firmware Update
Advanced
With this group of settings you can select, configure, measure and edit coordinate systems.
Displays current active coordinate system.
You can select active coordinate system either using the standard coordinate system G-codes G54,G55,G56…. or using Machine/Coordinate System/Select feature.
You can select active coordinate system number from drop down menu.
Sets work position values of all axes to zero.
Active Coordinate system offset values are calculated so that current work position becomes zero.
This program feature is scriptable.
For more info regarding Scripts, please read chapters Scripts.
Set new coordinate system position values and rotation for all 9 axes.
To set new position value for selected axis, enable axis radio button, insert axis position value and click OK.
Copy From
![]() |
|
This program feature is scriptable.
For more info regarding Scripts, please read chapters Scripts.
Sets work position value to zero for selected axis.
Active Coordinate system offset values are calculated so that current work position axis becomes zero.
User can select axis from sub menu.
This program feature is scriptable.
For more info regarding Scripts, please read chapters Scripts.
Measures Z axis offset value of active coordinate system.
Z axis will start descending at current position and when sensor/probe input is activated (e.g. surface of material), software sets Z axis offset of active coordinate system.
To avoid any damage, software safety feature will notify you if sensor/probe is not configured in settings.
This program feature is scriptable.
For more info regarding Scripts, please read chapters Scripts.
Sets offset values of all axes to zero.
This program feature is scriptable.
For more info regarding Scripts, please read chapters Scripts.
Set new coordinate system offset values and rotation for all 9 axes.
To set new offset value for selected axis, enable axis radio button, insert axis offset value and click OK.
Copy From
![]() |
|
This program feature is scriptable.
For more info regarding Scripts, please read chapters Scripts.
Sets offset value to zero for selected axis.
User can select axis from sub menu.
This program feature is scriptable.
For more info regarding Scripts, please read chapters Scripts.