Sidebar

Home



PlanetCNC TNG


Introduction
Overview
Installation


User Interface


Main Window

File Menu

View Menu

Program Menu

Machine Menu

  Emergency Stop
  Start
  Stop
  Pause
  Start Options
  Overrides
   Speed Override
   Spindle Override
   Pause Enable
   Pause Optional
   Single Step
  Mist
  Flood
  Spindle
  Output
  ExtOut
  Motor, Limits, Probe
   Motors Enable
   Soft Limits Enable
   Hard Limits Enable
   Probe Trigger
  Tools
   Current
   Change
   Select
   Edit Tool Table
   Edit Tool Slots
   Measure Current Tool
   Measure All Tools
  Move
   To Zero
   To...
   Axis To Zero
   To G28, G30
   To Selected Line
   To Mark
   Program Bounds
   Position To Camera
   Camera To Position
   Camera To Sel. Line XY
  Machine Position
   To Zero
   To...
   Axis To Zero
   Unwind
   Measure Height
   As G28, G30
   Reset THC
  Work Position
   To Zero
   To...
   Axis To Zero
   From Program
   Measure Height
   Offset To Zero
   Offset To...
   Offset Axis To Zero
   Selected Line
   Camera
  Coordinate System
   Current
   Select
   To Zero
   To...
   Axis To Zero
   Measure Height
   Offset To Zero
   Offset To...
   Offset Axis To Zero
   Edit Coordinate Systems
  Tool Offset
   Enabled
   To Zero
   To...
   Axis To Zero
   Measure Length
   From Tool Table
  Home
  Cycle
   Mill Facing
   Mill Profile
   Mill Pocket
   Mill Circular Pocket
   Drill
   Drill Tap
   Turn Facing
   Turn Roughing
   Turn Repeating
   Turn Finishing
   Turn Grooving
   Turn Threading
  Measure
   Probe Calibration
   Edge Find
   Edge Position
   Edge Angle
   Inside Corner
   Outside Corner
   Hole
   Protrusion
   Slot
   Tab
   Surface Height
   Surface Angle
   Surface
   Gantry Square
  Points
   Count
   Load
   Save
   Save STL
   Save DXF
   To Output
   Clear
   Add From Position
   Add From Camera
  Camera
   Show
   Mark
   Read
   Calibrate Scale
   Set Offset
  User Commands
  Controller
   Reconnect
   Reset
   Firmware Update
   Advanced

Help Menu


Settings



Parameters


tng:machine_menu:machine_menu-tools_edit_tool_table-toolchange

Edit Tool Table - Tool Change

General - Offset - Tool Change - Custom - Parameters - Speed & Feed

Toolchange Position
These are automatic tool change position values of selected tool. When automatic tool change is initiated, machine will use these position values to mount or dismount requested tool.

These values are also available as parameters so you can use them in any way you want or need when configuring tool change script file.

Skip Tool Change
When enabled, selected tool will not use tool change procedure e.g. Laser.

Skip Tool Measure
When enabled, selected tool will not be measured with fixed tool sensor e.g. Probe.

Sensor Offset
If measured tool uses e.g. cutting flutes that are eccentric to tools geometry and machine would need to measure it with an eccentric offset value, then this value represents machine offset so that tool can be successfully measured.

tng/machine_menu/machine_menu-tools_edit_tool_table-toolchange.txt · Last modified: 2023/01/31 22:29 by 127.0.0.1

Page Tools